Installation Guide for Shower Water Softener System

Please watch our installation video for your shower water softener system for helpful visual instructions. If you have any questions, feel free to contact us at service@softwatercare.com.

  1. Place the product in a suitable location
  2. Prepare the short connecting hose to link the filter and the softener
  3. Unscrew the hose connected to the shower head, make sure the rubber washer is in place, then attach it to the pre-filter
  4. Place the rubber washer properly, choose a hose of the appropriate length from the kit, and connect it to the softener's water outlet
  5. Turn the two vertical valve switches on top of the softener to ensure water flows through the system
  6. Turn on the shower and let the water run for about 3 minutes to flush out any small particles from the new softener
  7. Connect the other end of the hose to the shower head, again, make sure the rubber washer is properly installed

Your shower softening system is now successfully installed, Enjoy your soft water experience right away

If you’re using a wall-mounted showerhead, you’ll need to switch to a handheld showerhead to fit the system.

TRANSFORM SKIN & HAIR

System Installation FAQ

1. Is the system compatible with my shower?

Yes—as long as you’re using a handheld showerhead.

If you currently have a wall-mounted (fixed) showerhead, you’ll need to switch to a handheld one.

We also offer a compatible handheld shower set here:

👉 View Shower Set

2. Does the system work in all countries?

Yes. Our system uses a standard 1/2" (G1/2) connector, which is compatible with most showers worldwide.

No special tools or adapters are required.

3. How do I install the handheld showerhead?

If you’re replacing your showerhead with a handheld one, you can follow this general video guide:

👉 Watch on YouTube

4. What if I notice a leak after installation?

Leaks are rare but easy to fix. Here’s how to troubleshoot common cases:

  • Leak at the hose connection: Make sure the rubber O-ring is properly seated. Adjust or replace if needed.
  • Leak at the ACF filter cap: Use the included filter wrench to tighten the cap securely.
  • Leak at the brass elbow joint: Remove it using the brass wrench, apply extra plumber’s tape, then re-tighten.

How Users Installed It